How can I read a TPMS tire sensor using the CYD-2432S028?

[thenorhstar]

Hi everyone,
I have a yellow CYD-2432S028 ESP32 board and a CC1101 module. I’m trying to read TPMS (Tire Pressure Monitoring System) sensors using the Bruce firmware, but I could use some help.
​Since I just bought the board, I'm not sure which specific firmware version I should flash or which settings are required. I have 4 sensors, but I’m currently unable to receive any data. Does anyone have experience with this setup? I would appreciate any guidance on the correct configuration. Thanks in advance!

[thenorhstar]

Thank you for your interest. Yes, it is necessary for the vehicle to move or for the sensor to be shaken. However, before doing that, what kind of settings do I need to configure on the device? Could you please assist me with this? If available, could you send a video? Best Regards 6 Nis 2026 Pzt 12:09 tarihinde sp3rat ***@***.***> şunu yazdı:

…

*sp3rat* left a comment (BruceDevices/firmware#2359) <#2359 (comment)> W moim przypadku aby odebrać sygnały z TPMS musiałem rozpcząć jazdę samochodem. Czujniki muszą być w ruchu. Wówczas nadają sygnał. — Reply to this email directly, view it on GitHub <#2359 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ARSVUDLIDFG4BKQ6HH76XBD4UPJBXAVCNFSM6AAAAACXNPZUTCVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHM2DCOJTGM4DAMBZHA> . You are receiving this because you authored the thread.Message ID: ***@***.***>