Can't connect to Pulseview on MAC

[ollybowman]

I've compiled this and installed it on the ESP32, but i can't connect to it in pulseview at all, the scan just doesn't see the board.

I've tried adding #define USE_SERIAL2_FOR_OLS 0 and #USE_SERIAL2_FOR_OLS 1 but neither of those make a difference. I'm using pulseview on a mac.

Am i missing something here?

[EUA]

Not tested under mac. Normally, you should need to detected by pulseview if you correct baud rate for the device. Working O.K. under Linux. Will test on mac.

[EUA]

Hi, using latest code, there are no USE_SERIAL2_FOR OLS.... but just DEBUG_MODE
Debug mode use serial 2...

I think, only you should do that use latest close and remove #define DEBUG_MODE or change it to _DEBUG_MODE_x on header file definition... Unfortunately, I leave code in debug mode :) After that, ESP32 will be detected on Mac PulseView...

Edit: Closed debug mode at latest version.