Docs/build Requests

[kaseypocius]

Some general notes from the workshop today

• put screws and cables into trill board before mounting into the enclosure
• more screws for ESP32/enchanti board or washers so the board sits flat in the enclosure. We had to double-sided tape ours into the enclosure to make it flat
• make SPI & I2C cables different colors/standardize cable colours
• stress relief or protection for SPI & I2C cables with double sided tape or something similar to protect connectors
• add cable tie materials? or an area to mount cable management above the trill board

[aburt2]

Thank you for the feedback @kaseypocius
Could you send me some pictures for how the enchantiS3 boards are sitting in the endcap? they sit flat in the 5 T-Sticks I made in Australia.

[kaseypocius]

@jtragtenberg @Gael514 do either of you have photos of the board in the t-stick (or are in the lab and can grab a photo of t-stick 516?)

[Echo078]

It's kind of dependable ~ For 2 of the t-sticks we just made, it's not flat while others remain ok. I would say it depends on the force & order for screwing the board. (The best way to make it flat is to screw both screw at the same time instead of screw one then the other ---- could be add as a tip on the documenting website)