LedPower1 *AND* LedPower2 control blue LED, no red LED

[peteDDD]

I installed tasmota-lite.bin,gz and things seem to work fine.
I upgraded to the full tasmota.bin.gz and now LedPower1 and LedPower2 both control the blue LED. I cannot control the red LED.
Here are things I know and have tried: NOTE THAT THERE IS A WORKAROUND BELOW but it still seems that this should work)

1. Did a full reset of the PLF12.
2. Connected to 192.168.4.1 and provided SSID and password.
3. Connected to PLF12 through the new SSID at DHCP assigned address of 192.168.1.228
4. Used Configuration/Other to set the Template (Activate/Save)

{"NAME":"Kauf Plug","GPIO":[0,320,0,32,2720,2656,0,0,321,224,2624,0,0,0],"FLAG":0,"BASE":18}

5. Confirmed the settings on Configuration/Template page:
   1.
6. Conducted the following commands. Note that "LedPower2 1" gets an result of "LedPower1":"ON" (and similar for trying to turn Led2 off. In all cases LedPower1 or LedPower2 controls the BLUE LED. (very strange indeed)

7. I have also tried a variety of settings for LedState and that does not help.

8. Failed to find anything like this on the internet...

9. Tried to downgrade to tasmota-lite but the upgrade process apparently prevents that.

WHAT DID WORK FOR A WORKAROUND..... If I change GPIO1 to Relay_1 2 then I can control the Red LED using Power2 1 or Power2 0.

Here is my config information.

Any ideas are greatly appreciated!