Simple fillet on cube edge is not working: No common edge was found

[jtran]

No common edge was found between line2 and line3

sketch001 = sketch(on = XY) {
  line1 = line(start = [var 0mm, var 0mm], end = [var 100mm, var 0mm])
  line2 = line(start = [var 100mm, var 0mm], end = [var 100mm, var 100mm])
  coincident([line1.end, line2.start])
  line3 = line(start = [var 100mm, var 100mm], end = [var 0mm, var 100mm])
  coincident([line2.end, line3.start])
  line4 = line(start = [var 0mm, var 100mm], end = [var 0mm, var 0mm])
  coincident([line3.end, line4.start])
  coincident([line4.end, line1.start])
}
region001 = region(point = [50mm, 0.0025mm], sketch = sketch001)
extrude001 = extrude(region001, length = 100mm)
fillet001 = fillet(
  extrude001,
  tags = getCommonEdge(faces = [
    region001.tags.line2,
    region001.tags.line3
  ]),
  radius = 5mm,
)

Slack

[jtran]

As far as I can tell, the region code above uses the same engine commands as when using sketch v1, and that works. So I think this is an engine side issue.

sketch001 = startSketchOn(XY)
  |> startProfile(at = [0mm, 0mm])
  |> line(endAbsolute = [100mm, 0mm], tag = $line1)
  |> line(endAbsolute = [100mm, 100mm], tag = $line2)
  |> line(endAbsolute = [0mm, 100mm], tag = $line3)
  |> line(endAbsolute = [0mm, 0mm], tag = $line4)
extrude001 = extrude(sketch001, length = 100mm)
fillet001 = fillet(
  extrude001,
  tags = getCommonEdge(faces = [
    sketch001.tags.line2,
    sketch001.tags.line3
  ]),
  radius = 5mm,
)