diff --git a/firmware/klipper_configurations/M8P/Voron2_M8P_config.cfg b/firmware/klipper_configurations/M8P/Voron2_M8P_config.cfg
index f6c1a0d5..eec3755f 100644
--- a/firmware/klipper_configurations/M8P/Voron2_M8P_config.cfg
+++ b/firmware/klipper_configurations/M8P/Voron2_M8P_config.cfg
@@ -215,10 +215,11 @@ enable_pin: !PD9
 ##	If you ask for 100mm of filament, but in reality it is 98mm:
 ##	rotation_distance = <previous_rotation_distance> * <actual_extrude_distance> / 100
 ##  22.6789511 is a good starting point
-rotation_distance: 22.6789511	#Bondtech 5mm Drive Gears
-##	Update Gear Ratio depending on your Extruder Type
-##	Use 50:17 for Afterburner/Clockwork (BMG Gear Ratio)
-##	Use 80:20 for M4, M3.1
+rotation_distance: 22.6789511   #Bondtech 5mm Drive Gears
+##  Update Gear Ratio depending on your Extruder Type
+##  Use 50:10 for Stealthburner/Clockwork 2
+##  Use 50:17 for Afterburner/Clockwork (BMG Gear Ratio)
+##  Use 80:20 for M4, M3.1
 gear_ratio: 50:17				#BMG Gear Ratio
 microsteps: 16
 full_steps_per_rotation: 200	#200 for 1.8 degree, 400 for 0.9 degree
@@ -414,15 +415,15 @@ z_hop:10
 
 ##	Gantry Corners for 350mm Build
 ##	Uncomment for 350mm build
-gantry_corners:
+#gantry_corners:
 	-60,-10
 	410,420
 #	Probe points
-points:
-	50,25
-	50,275
-	300,275
-	300,25
+#points:
+#	50,25
+#	50,275
+#	300,275
+#	300,25
 
 #--------------------------------------------------------------------
 speed: 100