This can occur after homing any axis, but I will use Z as it is the most excessive and most likely to cause damage.
Once homed, if I try to lower the z axis, it will immediately move 60mm + amount asked to lower. I dont have any offsets set and the macpos reflects the DRO exactly. After the initial big move, it will then track normally. The excess move will also only occur when using the jog UI, lowering with the code does not cause the issue.
Not really a massive deal breaker, just a oddity
This can occur after homing any axis, but I will use Z as it is the most excessive and most likely to cause damage.
Once homed, if I try to lower the z axis, it will immediately move 60mm + amount asked to lower. I dont have any offsets set and the macpos reflects the DRO exactly. After the initial big move, it will then track normally. The excess move will also only occur when using the jog UI, lowering with the code does not cause the issue.
Not really a massive deal breaker, just a oddity