Replies: 1 comment
-
Dont worry all resolved, wire tweaked in the connector all working fine now! |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
So I have gone from an skr 1.3 board to skr 1.4 and everything seems to work, but on the first print, the part cooling fan is not activating at all. The scenario is as follows - begin a print (PLA) all calibration and z offsets work perfectly, the purge layer goes down no problem, first layer goes down no problem, then at the start of the second layer when the fan would kick in, unless it would kick in first layer? I get 3 or 4 beeps or so, nozzle lifts 20mm or so then the board reboots. If I plug the fan back into the skr 1.3 it works. The fan on the skr 1.4 is plugged into P2.3 Fan0 as per the documentation and when I go into the menu and run fan speed up to 100% nothing.
So my question is how do I fault find this problem?
Cheers!
Beta Was this translation helpful? Give feedback.
All reactions