RTKRCV not processing UBX inputs

[WhatASillyGoose]

I have installed RTKLIB on my Windows 10 machine using a U-Blox ZED-F9P as my rover and an NTRIP client as my base. I have set the input of the rover to serial and the format to u-blox and the base station to NTRIP client using RTCM3. Reading the logs I can see that the rover and the base are giving me valid data and I even checked the UBX contents of the rover for their integrity with this tool: https://github.com/sparkfun/SparkFun_u-blox_GNSS_Arduino_Library/blob/main/Utils/UBX_Integrity_Checker.py
On the rover I activated the RXM-RAWX and RXM-SFRBX messages as well as the NAV-SAT, NAV-SIG, NAV-PVT, NAV-POSLLH and NAV-HPPOSLLH messages. In the built-in RTK Monitor of RTKNAVI I can also see the UBX messages arriving as well as the RTCM3 messages of the base station. In the end unfortunately there is not output at all but also no error messages. I have tried around a lot and debugged as far as I possibly can but at this point I am out of ideas. Rover and base inputs seem to be fine and also the ZED-F9P definately receives signals as it's positioned well. I even checked with the u-center software to make sure the ZED-F9P works and also tried it with the same NTRIP client with 8cm accuary.

[javadtaghia]

did you get any result? i have the same issue ...

[WhatASillyGoose]

Unfortunately not. I had to drop that and use RTK via the internet.