Control Signals Diagram

The image belo shows the control signals of the floripasat cubesat.

Remove Before Flight (RBF)

Cut all power to the satellite once it is inserted into the satellite.

Enable Payload 0 (EN_P0)

Enable the experiment of the RUSH payload.

Enable Payload 1 (EN_P1)

Enable the experiment of the joinville payload.

Transceiver Reset (Transc_RST)

Reset pin of the transceiver of the cubesat

Transceiver General Purpose Pins (Transc_GPIO0)(Transc_GPIO1)(Transc_GPIO2)

General Purpose pins for future use.

RF Switch Control (RF_SWT_TX)(RF_SWT_RX)

Pins to control which signal goes to the antenna. More info at the TTC Rf switch section

Enable Power Amplifier regulator of Beacon (EN_R_PA_Beacon)

Enable the power of the Amplifier of the beacon.

Enable Power Amplifier regulator of Transceiver (EN_R_PA_Transc)

Enable the power of the Amplifier of the Transceiver.